Ultrafiltration membrane with epoxy resin 1045A/H-120B

I. Introduction: 1045A/H-120B Department of transparent epoxy resin Shui Jingjiao elastic or flexible epoxy potting material, a mixture of low viscosity, can be used for a long time after curing transparency and good electrical properties, can be added to a variety of colors .

Second, the conventional performance:

Test Project
 Testing methods or conditions
 1045A
 H-120B
 
Appearance
 Head Measurement
 Purple transparent liquid
 Light yellow transparent liquid
 
Density
 25 ℃ g/cm3
 1.1 ~ 1.2
 1.02 ~ 1.2
 
Viscosity
 40 ℃ mpa · s
 800 ~ 1300
 30 ~ 100
 
Shelf life
 Room ventilation
 Six months
 Six months
 

Third, use:

Item
 Units or conditions
 1045A/H-120B
 
Mixing ratio
 Weight ratio
 100:100
 
Use of time
 25 ℃, hrs
 0.5 ~ 1
 
Curing conditions
 ℃ / hrs
 25/12 ~ 24 or 60 / 3 or 80 / 1 ~ 2
 
 

1. Tools: electronic scales, measuring cup (such as: plastic cups, paper cups), glass (or mixing gun);

2. Weighing: Open electronic scale, remove the skin above the measuring cup placed in heavy plastic with 100 grams of 1045A, and then adding 100 grams of H-120B gel. (Note: 1. Must be to weight ratio, some customers do not electronic scale, the amount of his take on the use of cylinder which is not desirable, because not the same as the proportion of AB glue, it is difficult to do the right proportion of cases, so with a good cause glue does not harden. 2. Do not pay more or less by adding B to control the glue hardening glue speed, otherwise it might not harden.)

3. Mixing: AB will be weighing a good mixture of glue, use a glass rod to mix (vertical and horizontal rotation) about 3 minutes (Note: If mixing uneven and may lead to local non-hardening phenomenon.)

4. Package: one by the stirred mixture of glue into the pre-prepared products (preferably within half an hour run out to prevent the glue in chemical reactions produce large amounts of heat, leading to rapid rise in viscosity glue, short rapid hardening).

5. Curing: 25 ° / 12 to 24 hours or 60 / 4 hours or 80 degrees / 1 to 2 hours

6. Cleaning: You can use acetone or anhydrous alcohol.

Fourth, use:

For LED luminous characters, soft lights, metal badges, signs and other needs to be transparent flexible packaging components.

Fifth, cured hardness: 35 ~ 50D

VI, packaging specifications:

Packing for the 1045A: 5KG ± 90g plastic bucket; H-120B: 5KG ± 90g plastic bucket or other container.

 * Note: The above performance data for the product in 70% humidity, temperature 25 ℃, the typical test data for reference purposes only customers, and can not guarantee that a particular environment can be achieved when all the data. Please use customers, subject to the measured data.